![]() ![]() Plug in your modem and click the 3G/4G tab in Internet Settings to enter the 3G/4G setting page. You can connect to the Internet using 3G or 4G modem. In case your main router doesn't support WDS, you can create a WISP connection first, then set up a relayd overlay. However, you need to find out this IP in the admin UI of your main router if you want to access the web UI of GL.iNet router again. If you are not sure, just keep the LAN IP blank so that it will get a IP address from your main router automatically. This LAN IP should be within the subnet of your main router, but it cannot conflict with any other devices's IP within the same subnet. Choose WDS in mode and you can enter the LAN IP which will be used to access this router. Then, choose a SSID and enter its password. Click Repeater tab in Internet Settings, the router will search for the available Wi-Fi networks automatically. To set up repeater in WDS mode, first, ensure your main router supports WDS. Note: OpenVPN client function of the mini router will not work in bridge mode. Check your main router's manual to see if it supports this function. Since WDS has different implementation, you'd be better to use the same GL.iNet router. However, to use this mode, your main router has to support WDS. There is no firewall between the mini router and the main router. Therefore, the router only act as a device to extend the wireless signal coverage of your main router. In WDS (Wireless Distribution System), you can connect to an existing wireless network without creating a new subnet. To set up repeater in WISP mode, first Click Repeater tab in Internet Settings, the router will search for the available Wi-Fi networks automatically. So all your devices connected to GL.iNet router will be protected by its firewall. Suppose its netmask is 255.255.255.0, GL.iNet router will have two IP address:ġ92.168.1.99 which is obtained from your main router In the following diagram, your main router has an IP 192.168.1.1. Therefore, we highly suggest you to chose WISP if you want to connect to a public wifi. In WISP (Wireless Internet Service Provider) mode, the router will create its own subnet and act as a firewall which protect you from the public network. However, there are 2 different modes that you can choose. You can connect to an existing wireless network by setting it as a repeater. Generally, your ISP will give you a modem and provide you a username and password that you are required to enter so as to access the Internet.Įnter your username and password then click Submit. PPPoE is required by many Internet service providers (ISP). Change it according to your needs, then click Submit. The current settings will be automatically filled. Static is required if you want your router have a fixed IP address given by your ISP or in the same subnet of your main router. You just need to choose DHCP and click Submit. ![]() Cable DHCPĭHCP is the default and most common method to connect to the Internet. You can click New Connection to create an Internet connection. There are total 4 different connection methods that you can use to access the Internet:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |